Join Date: Sep 2015
Location: San Diego
Mentioned: 38 Post(s)
Tagged: 0 Thread(s)
Quoted: 956 Post(s)
Just picked up a cheap van as my bike hauler. Anyone know rh spacing between the 4 bolts for the pit bull trs? Anyone selling a cheapish used one? The mount taker is universal correct? Just change out the pins?
I'm not sure on the hole spacing either but I believe the plate is 6"x24". I've got mine in a full size chevy van. You will want to make sure the plate holes are on top of the ribs inside the van and you can use about a 5" long washer underneath to make sure it tightens up correct between the ribs, I used some 1/4" thick 1" wide stock for that.
Hope this helps.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Review of Pit Bull Forward Handle Rear Stand||JimGnitecki||Yamaha R3 General Discussion||19||02-19-2018 09:04 AM|
|The MEGA Spools and Stands Thread||Mike-the-Bike||R3 Parts and Accessories||102||10-07-2016 02:22 AM|
|Pit Bull rear stand||rviator||R3 Parts and Accessories||16||07-08-2016 10:49 PM|
|How do I mount the Pit Bull Trailer Restraint?||DenverR3||Yamaha R3 General Discussion||6||07-07-2016 10:15 AM|
|Got a pit bull stand.... bolt size?||Vince||Yamaha R3 How To & DIY||15||09-29-2015 04:43 PM|