Yamaha R3 Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Electronics
    I recently installed some TSTIndustry pod lights for my rear tail lights as well as a new blinker relay. The installation went smoothly and power is going through. The issue Im having is my right turn signal stays on solid. The left works just fine, blinks at a good pace and turns off upon...
  2. Electronics
    Hi, Firstly, I am new to riding and got my R3 (first bike) a couple of weeks ago. I installed two new blinkers with a built-in relais for the rear of my R3. I noticed the blinkers cause a concerning heat on the marked part in the picture below. Could you maybe tell me what is causing this heat...
  3. Electronics
    Hello all, I need some advice. I bought a used 2015 R3 early last year. No manual and no history. I downloaded the service manual, but I'm not very mechanically savvy (yet), so I'm hoping someone can point me in the right direction to start troubleshooting. I had the bike in the bed of a...
  4. Electronics
    Was wiring up a license plate light the other day and it looked good. This morning when I took my bike out, the tach did the regular start up spin, but after that, it and the speedometer were out of commission. Tach won’t budge and speedo says 0MPH while riding. There’s also an engine light on...
1-4 of 4 Results
Top