[craigfer63]

8/2016 YZF R3 ABS.
I have removed the ABS from my bike.
To keep the speedo and odometer working, I left the rear wheel sensor on. I removed the aluminum block from the ABS ECU and zip tied ECU up to the frame.
Question, can I remove the ABS ECU and join the Br (Brown) and Y (Yellow) wires, from Rear Wheel Sensor to wires going to the ECU , eg. join Br to B or B/W ?
And join Y to W. From the ABS ECU connector ?
I see there is an ABS ECU eliminator, available in the USA, this is A$400.
My next step is to disconnect the W/L (White/ Blue) wire to the ABS warning light and see what happens ?
Can anyone help with advice here ?

 

[Maverick84]

What are you planning to do with the OEM ABS kit of R3, I have a Non-abs bike, and if this fits, would like to buy it from you..


Sent from my iPhone using Tapatalk

 

[craigfer63]

What are you planning to do with the OEM ABS kit of R3, I have a Non-abs bike, and if this fits, would like to buy it from you..


Sent from my iPhone using Tapatalk

Very difficult to add ABS to your bike.
You would need new wiring harness and ECU, + all the ABS components.
Not possible.