Yamaha R3 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 · (Edited)
I just bought clutch n break levers on ebay.
I installed it today. Being a noob, didn't realize I had to readjust the clutch so there is a little free play.
But can't figure out how to do it.
I read other posts and looked at youtube videos.
Yet, it looks so different from the video.
Right there is no free play whatsoever. How do i make it loose?



 

·
Registered
Joined
·
124 Posts
It's 7-19 and 7-20 in the USA manual. Start at step 5, since you've already got the fairing off and the barrel adjuster at the lever adjusted all the way loose (as it should be when installing a new cable, so you've got plenty of room to take up any slack that develops as the cable seats itself).
 

·
Registered
Joined
·
45 Posts
If you look at the knurled nut (large item). You loosen it first and and then screw the smaller nut behind it out. As you do, the lever will go in. After you get the looseness you want, tighten the large knurled nut tight again. I suggest using a pair of plyers because that large nut is on quite tight.
 
1 - 4 of 4 Posts
Top