Yamaha R3 Forums banner
1 - 12 of 12 Posts

·
Registered
Joined
·
74 Posts
Don't like any if them and for a 1/5th of the price I paid for the bike. No thanks.
 

·
Registered
Joined
·
74 Posts
Oh **** didn't even realize it was for each.. Fuckkkkkkkkkkkkkk that!!! lol
 

·
Premium Member
Joined
·
971 Posts
Lighten the wallet for sure - but then again, the Galespeed race wheels (forged) run $650 front, $850 rear. Stockers are cast aluminum, so the blingers (billet) would likely be a bit lighter, depending on pattern. Funny, according to their site, they are "forged billet" (not likely, just machined billet) Still - more show than go I'm guessing.
 

·
Premium Member
Joined
·
2,264 Posts
Discussion Starter · #9 · (Edited)

·
Registered
Joined
·
121 Posts
Probably he means the blank is forged and then finished machined. That's how they are normally done. Forging is way too rough to get the finish and tolerances you'd need.

Marc
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top