Yamaha R3 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
Hello Friends,
I have had the famous Error Code 19 happen to me now.

Its erratic. Comes on at times and then the bike shuts down. Wont start at all. After some time it will go away and then bike runs fine for 2-3 days. This is happening for the past week.

I have searched the earlier post on this forum regarding the error and got to know that this error might be due to a number of reasons..and most probably its due to a faulty side-stand switch.

Does any one know how one can enter into the diagnostic mode (if there is one) of the ecu and then find out what's the exact problem. I have another bike which has this feature where in if certain keys are pressed in combination the ECU enters the diagnostic mode and gives certain number of beeps corresponding to the error. Wondering if R3 has something similar.

I am planning to take the bike to the service centre anyways over the weekend.

regards,
Jawed, India
 

·
Registered
Joined
·
29 Posts
Discussion Starter · #2 ·
An Update.

Apparently there is no separate diagnostic mode in R3. The fact that it shows error code 19 is itself the diagnostic output.

The service center took apart all the wiring interconnects and cleaned them and put them back in.

They found two connections loose. One on the ECU and another on the horn.

I hope now the bike runs smoothly.

regards,
Jawed
 
1 - 2 of 2 Posts
Top