Yamaha R3 Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
Hi all I am getting the R6 throttle tube and I was thinking abt getting new grips as well. since its off anyway.
does the clutch side also fit from a 2008 R6 as well?
that way I'll just buy R6 grips and wont hve to mix n match ?
 

·
Registered
Joined
·
84 Posts
R6 throttle tube uses the exact same grip as the R3 throttle tube; therefore, it will match your stock R3 left bar grip. No need to replace.
 
  • Like
Reactions: Gizmo and Kojiiro

·
Registered
Joined
·
78 Posts
Discussion Starter · #3 ·
Sweet. I saw some pictures where the grip looked different so I didnt want 2 different grips. is all. Thanks
 

·
Registered
Joined
·
237 Posts
If you did decide to get new grips, I would personally use Renthal soft (light gray) grips. I use them for roadracing, and, in my humble opinion, they offer the best feedback through the bars you can get. They may not offer the longest durability, but at $15 or less for a pair, you can't go wrong.

Just my $0.02!
 
1 - 5 of 5 Posts
Top