Yamaha R3 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 · (Edited)
Ok so, without realizing people on this forum were already getting creative with their stock rear fender parts..I came up with this simple creation! I call it the 'keneliminator' kit...completely DIY! I used the stock steel brackets for the rear fender, shimmed them with the thick washers from the rear fender mounts to give it a better angle and relocated the license plate light..and voila!! (had to drill/slot out the top hole in my license plate) I also have TST flush mount signal lights on order which I plan to install in the same area as well as replace the fronts for a totally LED and clean look. I also ordered an LED flasher relay.. will tape over remaining holes but this mod is 100% reversible..

Hope this might work for other enthusiasts. Other mods will be simple, a few sliders, up the preload on the rear shock and enjoy! What a great bike, very happy with it

K
 

Attachments

  • Like
Reactions: TheRealJoker31

·
Registered
Joined
·
74 Posts
Nicely done, and welcome!
 
1 - 2 of 2 Posts
Top