Yamaha R3 Forums banner

Whatcha think?

1 - 3 of 3 Posts

55 Posts
Discussion Starter · #1 ·
I got my new slip-on yesterday from LeoVince via AF1 racing and i love it. I WILL say that if you go this route, clean the output pipe from the cat to accept the new gasket more easily. It was a B**** getting the new one on without proper cleaning from the old one. Lesson learned. Also because it wasnt able to FULLY bottom out i had to use a Dremel on the rear foot peg where it was too close, also it only works with the stock passenger foot peg so i had to remove my aftermarket bracket that deletes the rear pegs, oh well.
Wheel Tire Fuel tank Vehicle Automotive lighting
Tire Wheel Motor vehicle Automotive tire Automotive lighting
1 - 3 of 3 Posts