Yamaha R3 Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
I replaced the GG Retrofitz tail with a TZ250 race bike replica tail. I had to cut off about 8" of the rear subframe to make it fit so there's no going back. Also made a seat pan out of fiberglass and bought a TIG welder to fabricate a bracket to hold the new tail light and plate holder. And since I learned to weld I bought another side stand and lengthened mine by 3/4" so the bike doesn't lean over as much. Now it's just right. And lastly I pulled the old vinyl wrap off and gave it a fresh look for 2020.
 

Attachments

1 - 5 of 5 Posts
Top