Picutres needed, so i can repair my R3

1486 Views 4 Replies 3 Participants Last post by Marcc, Jan 12, 2016

TheRealJoker31

Discussion Starter · Jan 11, 2016 (Edited)

Hello Riders

I smashed my R3 as some of you know.
But i Need some Pictures to understand how to repair it.
The Partzilla Pictures are not enough for me to understand how to repair.
I changed the Stay (the Thing which covers the Meter) and the Shift Shaft.

Need some Pictures of the shift shaft, the Headlight and the rear brake pedal.

Thanks very much

I did a mistake, the Footlever is hanging to much

See less See more

Save

1 - 5 of 5 Posts

Bird

· #2 · Jan 12, 2016

You have the piece attached to the transmission spline too far back. Rotate it towards the front so its a bit closer to 90 degree angle.

See less See more

Save

TheRealJoker31

Discussion Starter · #3 · Jan 12, 2016

Bird said:
You have the piece attached to the transmission spline too far back. Rotate it towards the front so its a bit closer to 90 degree angle.

Thank you, Sir! I'll correct it later

Could you say me how I'll find out to to connect everything (Headlight,Shell for Headlight, side fairings, etc.) Thanks

Save

Marcc

· #4 · Jan 12, 2016

You can whatch in Youtube the videos of STG, there they explain a little good how to remove and install some french parts.
Here in the forum there are some pics of an R3 without the front fairings, I don't know exactly where, but I'll look for it and post the link.
Good luck.

Save

Reactions: 1

Marcc

· #5 · Jan 12, 2016

I found it.

http://www.r3-forums.com/forum/777-...s-motorsports-race-prepped-yamaha-yzf-r3.html

Hope this help you!

Save

Reactions: 1

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month