Yamaha R3 Forums banner

1 - 3 of 3 Posts

·
Registered
2020 R3, 2022 Trident 660
Joined
·
88 Posts
so pull the pin out 1/3 - 1/2 way.
using fingers make the tip narrow by squeezing the 4 split legs.
put the assembly into the hole without pressing the middle pin.
place the assembly all the way in.
push the middle pin until it is flush with the rim
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
so pull the pin out 1/3 - 1/2 way.
using fingers make the tip narrow by squeezing the 4 split legs.
put the assembly into the hole without pressing the middle pin.
place the assembly all the way in.
push the middle pin until it is flush with the rim
Thank you for the reply, I will give that a try today.
 
1 - 3 of 3 Posts
Top