Yamaha R3 Forums banner

1 - 14 of 14 Posts

·
Premium Member
Joined
·
971 Posts
Discussion Starter #1
Both Hotbodies and Flexiglass are in the process of developing race plastics for the R3, but always seem to be about two weeks out. Anyone have bodywork sources (need in the next three weeks)?


Thanks
 

·
Registered
Joined
·
123 Posts
Catalyst Racing Composites in CA will usually give you a free set if they can use your bike to make plastics for a new model. Pretty sure they need the whole bike to do it but it's worth contacting them. Their bodywork is top notch; I've had 3 sets and they've all been sturdy and fit perfectly.
 

·
Premium Member
Joined
·
971 Posts
Discussion Starter #5 (Edited)
I haven't contacted CRC yet, but will tomorrow. They would need the bike for initial mock-up, test fit, etc., but not sure if I want to haul mine out there - but nothing's out of the question at this point. It was an unintended consequence of a new model - the availability of go-fast stuff lags behind.
 

·
Registered
Joined
·
717 Posts
I live in South Kansas City, Mo., so I'm nowhere near ANY race fairing manufacturers. Please keep us updated as soon as you figure it out!!!!!!!!
 

·
Registered
Joined
·
62 Posts
I actually ordered mine from there. They make them to order I believe because it is taking mine a little over a month to get them. I ordered on 4/21 and they didn't ship until 5/21 so I'm just waiting to receive them
 

·
Premium Member
Joined
·
971 Posts
Discussion Starter #10
I actually ordered mine from there. They make them to order I believe because it is taking mine a little over a month to get them. I ordered on 4/21 and they didn't ship until 5/21 so I'm just waiting to receive them


Please post up your impressions when they come in - pics or it didn't happen.
 

·
r3-forums.com Vendor
Joined
·
778 Posts
1 - 14 of 14 Posts
Top