Yamaha R3 Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
198 Posts
How do I go about removing the r3's four cylinder head studs?
1. Coat bolt with PB-Blaster at the base of the bolt.
2. Attach vice grips to bolt.
3. Lefty loosy - righty tighty


Pro-Tip: Replace step 2 with the following: Thread on a a nut all the way to the stud, thread on another nut and while holding the first nut, tighten the second nut into it fairly snug. Use wrench on first nut to remove bolt.
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #6 ·
1 - 6 of 6 Posts
Top