Yamaha R3 Forums banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I recently installed some TSTIndustry pod lights for my rear tail lights as well as a new blinker relay. The installation went smoothly and power is going through. The issue Im having is my right turn signal stays on solid. The left works just fine, blinks at a good pace and turns off upon flicking the switch but as soon as the bike is powered on the right light comes on and stays on.
Any input or guidance is appreciated. This is my first bike so I'm very new to any maintenance work.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.