Stock Clutch Lever

2018 Views 7 Replies 5 Participants Last post by beau_bygrace116, Feb 27, 2016

beau_bygrace116

Discussion Starter · Feb 27, 2016

Any tips on how to remove these from the factory? I'm looking to replace them with some CRG Shorty Levers but they are in there pretty tight!!

Save

1 - 8 of 8 Posts

foolishtank

· #2 · Feb 27, 2016

Here is a "how to" from STG

https://www.youtube.com/watch?v=C-kvdui3YRM

Save

beau_bygrace116

Discussion Starter · #3 · Feb 27, 2016

foolishtank said:
Here is a "how to" from STG

https://www.youtube.com/watch?v=C-kvdui3YRM

Hey!! Yeah, I've got the installation part down but I am having difficulty turning that larger screw to remove the cable. Was wondering if anyone else ran into that same issue!!

Thanks again!

Save

rito

· #4 · Feb 27, 2016

beau_bygrace116 said:
Hey!! Yeah, I've got the installation part down but I am having difficulty turning that larger screw to remove the cable. Was wondering if anyone else ran into that same issue!!

Thanks again!

https://youtu.be/3Bvw8iOqXyY

Save

Fyktion

· #5 · Feb 27, 2016

beau_bygrace116 said:
foolishtank said:

Here is a "how to" from STG

https://www.youtube.com/watch?v=C-kvdui3YRM

Click to expand...

Hey!! Yeah, I've got the installation part down but I am having difficulty turning that larger screw to remove the cable. Was wondering if anyone else ran into that same issue!!

Thanks again!

I could not get that part turned with my bare hands whatsoever. I had to put a rag over it and turn it using a pair of pliers to get them lined up to pull the cable out

Save

Kojiiro

· #6 · Feb 27, 2016

Fyktion said:
I could not get that part turned with my bare hands whatsoever. I had to put a rag over it and turn it using a pair of pliers to get them lined up to pull the cable out

A flat head or coin in the slot will turn it pretty easily as well.

Save

beau_bygrace116

Discussion Starter · #7 · Feb 27, 2016

Kojiiro said:
A flat head or coin in the slot will turn it pretty easily as well.

I tried the flat head initially and it kinda marred the finish a bit. It's no big deal. I went the rag and plier route and it took 2 seconds. Should posted before trying lol. But I've successfully installed the lever!

Thanks

Save

beau_bygrace116

Discussion Starter · #8 · Feb 27, 2016

Thank You!

Fyktion said:
I could not get that part turned with my bare hands whatsoever. I had to put a rag over it and turn it using a pair of pliers to get them lined up to pull the cable out

Thanks bro! I tried that and it worked like a charm. Only wish I posted for help before trying other ways. I went with a flat head and it kinda marred the finish of the adjuster nut. Not a big deal.

Thanks again!!

Save

1 - 8 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month