Yamaha R3 Forums banner
541 - 546 of 546 Posts

·
Registered
Joined
·
291 Posts
I totally agree. I use a pair of wind blocking earplugs that let other sound frequencies through. Not only do they block wind noise significantly, but they're as good as an aftermarket exhaust in terms of improving my bikes' engine sounds.

Sent from my SM-G965F using Tapatalk
 

·
Registered
Joined
·
28 Posts
Thanks Dreadwil. We pulled the pillion and plastic plate. Son just pulled the seat off and we didn't think anything of it until we started putting everything back together. Local dealer has them so will be paying them a visit tomorrow.
 

·
Registered
2018 R3
Joined
·
84 Posts
Vinyl-wrapped heel guards and trim panel between both seats. I was unable to break free the hex head bolts that secure the driver side heel guard, so I wrapped over them. This was my first vinyl wrap attempt so I’m not good at it. I got a couple of small creases on the trim panel. I’ll see how durable the wrap is and redo it if needed.

I think it looks ok, and I can always peel it off if I get tired of that look.
Tire Wheel Fuel tank Vehicle Automotive fuel system

Wheel Tire Vehicle Motor vehicle Automotive tire

Tire Wheel Land vehicle Fuel tank Vehicle
Tire Wheel Fuel tank Vehicle Automotive fuel system
Wheel Tire Vehicle Motor vehicle Automotive tire
Tire Wheel Land vehicle Fuel tank Vehicle
 

·
Registered
Joined
·
28 Posts
Started it up, put in gear, feathered the clutch the length of the backyard driveway in 1st gear to the street just to feel its massive torque compared to the POS KTM 200 Duke that tried everything in its power to get me to bugger the MSF course 😂 😂. Sadly, the whole exercise was to make room so I could pull out grill and get my munch-a-crunch on. Taking it for a spin after dinner.
 
541 - 546 of 546 Posts
Top